DM&P Mity SoC Development Kit Installation
Home : Products | Technical Support 2002/12/09

Install Mity SoC Module on Development Board

For easily develop, we provide Mity SoC development board for programmer. Be careful to install Mity SoC module because somebody will install Mity SoC module in wrong side. See the red rectangle of picture and ensure that you do the right way.


Install Mity SoC Module
Connectors (below table)
ID Description
1 AT power connector.
2 5V DC jack.
3 5V terminal block.
4 Bozzer.
5 DOC slot.
6 PC104 connector.
7 Keyboard connector.
8 Keyboard + PS2 mouse connector.
9 VGA connector
10 COM1 connector.
11 GPIO status LED.
12 GP15-12 test button.
13 COM2 connector.
14 Printer port connector.
15 GPIO connector.
16 IDE connector.
17 Port 80H

How to Develop ?

We provide serial port send/receive program for programmer to upload their program if they develop application on other machine. Or, there is a IDE connector on development board, so you can install hard disk to develop DOS application on it. We recommend programmer to use old/small hard disk that BIOS can recognize large hard disk (ex: 10G/20G/30G) but only 8 GB can be accessed. Programmer can make a 8 GB FAT32 partition or 4 * 2 GB FAT16 partition. Programmer also can install our PC104 network module (ex: ICOP-1500) if they want to use FTP (just run DSock FTPD.EXE to be a FTP server) to upload program. Refer to Setup Your Development Environment please.


Development board with LAN module
Our development environment

Technical Support

If you have any problem, feel free to mail to tech@dmp.com.tw please.

DMP Electronics Inc. All rights reserved. Email us: info@dmp.com.tw